Multicast routing protocols often do not
require non-RPF packets; these packets do not require software processing. The CPU therefore updates the hardware MFIB with a fast-drop entry when
it receives a non-RPF interface packet that PIM does not require. Additional
packets that match the fast-drop entry are not sent to the system software. Use the hardware counter feature multicast ipv4 command to
enable per multicast router ingress packets and byte counters.

However, it can’t be controlled and all senders could also be sending to one DLL address (to one node). Unfortunately, if a cached OL anycast destination becomes unreachable, it can’t be replaced until the cached entry times out. So for the unlucky nodes on the link with the unreachable address cached, the OL anycast is unreachable, but for all other nodes on the link the anycast is reachable. Delivering IP packets within a subnet (on-link) is different than delivering between subnets (off-link). This article examines those differences for unicast, multicast, and anycast destination addresses. The goal is to shine a light on the differences for anycasts and to explain on-link anycasting.

Step 2: Enable static

The example below shows how the waiting room kicked in at different times with respect to the active user threshold. Hover over any bar to display a tooltip with the exact values for the period you are interested in. Scrolling down the page, you will find visualizations of your user traffic compared to your waiting room’s target thresholds for Total active users and New users per minute. These two settings determine when your waiting room will start queueing as traffic increases.

• The process of delivering data from a source device to a destination device is known as transmission.
• There, you can create rules to assign a port number to a device or service on your network, and specify the protocol, such as TCP or UDP.
• Multicast addresses, such as video conferencing, online gaming, and streaming media, are used for one-to-many communication.
• And just because you have a high reputation score from a third party doesn’t mean you don’t risk throttling, landing Read More in the spam folder, or getting blocked outright.
• It is inherent to the forwarding process in the router, and it enables a router to use multiple paths to a destination when it forwards packets.

On the Cisco 7600 router, eight is the maximum number of ports that can be bundled. A hot standby port is bundled in (swapped into) an aggregation when a previously active port fails. •LACP port priority—You must configure an LACP port priority on each port configured to use LACP. The port priority can be configured automatically or through the CLI. LACP uses the port priority to decide which ports should be put in standby mode when there is a hardware limitation that prevents all compatible ports from aggregating.